Kern County, just over the county line

Rosamond is the next town north of Lancaster, and from there our Kern County list runs out to Mojave, Boron and California City, up to Tehachapi and over to the Tejon Pass towns.

The county, from Palmdale

3 towns on our list.

Kern County starts a few miles north of Lancaster. Rosamond and Edwards AFB come first, then Mojave, North Edwards, Boron and California City across the open desert, with the old mining towns of Randsburg and Johannesburg out past them. This is the same high desert we live in, just emptier: hot summers, cold nights, hard wind off the passes and dust that coats everything. Housing is mostly single-family on bigger lots, much of it on the newer side, along with military housing on base and older homes in the mining towns.

Farther west, Lebec, Frazier Park and Lake of the Woods sit up in the hills near the Tejon Pass, with snow in winter.

West of Mojave the road climbs to Tehachapi, Golden Hills, Stallion Springs and Bear Valley Springs, with Keene down the canyon. These mountain valleys sit from about 4,000 feet up, with real winters, snow some years and summers that stay cool by desert standards. Wind is a fact of life there too, and the canyon roads make the drive longer than the miles suggest.

Over the mountains to the north, Arvin, Mettler and Edmundson Acres sit at the south end of the San Joaquin Valley: flat farm country with hot summers, foggy winter mornings and plenty of agricultural and packing buildings. Those valley towns are near the far edge of our 60-mile radius, and the drive there crosses the mountains, so visits take planning.

Towns we cover in Kern County

Grouped by area, closest first. Distances are straight-line from our Palmdale shop; housing ages from the US Census.

The Mojave Desert side of Kern County3 towns, 20 to 30 miles from our shop, with typical homes from about 1976 to 2000.

Rosamond 20 miles north
Edwards AFB 24 miles northeast
Mojave 30 miles north

What the weather does to floors here

The Mojave Desert side of Kern County, where most of these towns sit.

Distance is part of the conditions out here. Towns sit far apart, so whatever a floor needs has to be on the truck before the crew leaves, and a forgotten bag of flake is not a quick run to the store. The weather adds its own surprises. Late summer can bring thunderstorms that push a wall of dust ahead of them and then drop rain fast, and unpaved driveways send mud and sand straight into garages afterward. Shops on big desert lots often sit at the end of dirt roads, which means tires bring the desert in with them every single trip.

Wind decides the coating days out here more than the calendar does. The crew grinds and repairs whatever the weather, then lays the base coat and top coat in the calmest window the forecast offers, which is usually early morning. We close up the building, seal the gaps at the bottom of roll-up doors, and blow out the walls and rafters before each coat, so dust that settled overnight does not drift down into wet resin.

What we do here

Desert Kern looks a lot like home, so the floor list does too: flake garages with UV-stable top coats, shop floors on big lots, and metal buildings that need a tough epoxy system. Up in Tehachapi and the Tejon Pass towns we would add anti-slip textures and pay close attention to the garage apron, where snowmelt and freeze-thaw do their damage. In the farm towns near Arvin, packing sheds and ag shops call for heavy epoxy or urethane cement that handles washdowns and equipment.

Rosamond and Edwards are close enough for quick visits from Palmdale. The mountain and valley towns get a set day, and winter jobs up high wait for weather warm enough to cure a coating. Commercial and industrial floors anywhere in the county are well inside our 150-mile range. Send photos first and we will tell you what we see.

Every service

Questions from Kern County

Do you cover Rosamond and Edwards AFB?

Yes. Rosamond is the next stop north of Lancaster and one of the closest towns on our whole list. For a home on base, let us know up front so we can plan the visit.

Can you coat a floor in Tehachapi in winter?

Sometimes. Cold slows the cure, so we watch the forecast and the slab temperature and book a mild stretch. If it is too cold, we would rather wait than lay down a floor that never cures right.

What floor fits a metal shop building out in the desert?

Usually a heavy epoxy system with a UV-stable top coat over a well-ground slab. Shops see dropped tools, oil and big temperature swings, so the prep and the top coat matter most. We look at the slab and how you use the space before we quote.

Is California City in your range?

Yes. California City sits inside our 60-mile home radius, out past Mojave. Visits get a set day, and we still look at the floor before giving a price.

Do you go out to Arvin and the farm towns?

Yes. They are near the edge of our home radius and well inside our commercial range. Packing sheds, ag shops and equipment bays usually want urethane cement or heavy epoxy, and we schedule those visits ahead and plan around your work hours.

Does the wind out here change how you work?

It does. Wind blows sand into wet coatings, so we keep the garage door mostly closed and time the coats for the calmer part of the day. On a bad wind day, moving the coating day is the honest call.

Call the shop Send a message